Safety Bulletin: Laceration Prevention Through Hazard Recognition and Task Planning

 

Two recent recordable injuries reinforce the importance of identifying hazards early, correcting them before work continues, and maintaining safe body positioning during routine tasks. Both incidents involved common work activities; however, each resulted in a serious laceration when known or foreseeable hazards were not fully controlled.

This bulletin is intended to reinforce three expectations: recognize hazards before and during the task, eliminate or control identified hazards whenever possible, and stay out of the line of fire when working near protruding materials, sharp edges, or equipment that may move unexpectedly.

 

Incident 1: Facial Laceration from Protruding Conduit

What Happened

An employee was loading scrap conduit into a trash buggy when they turned toward the container and contacted a piece of conduit protruding from the buggy. The conduit struck the bridge of the employee’s nose and caused a laceration that required medical treatment.

The employee recognized that the conduit was protruding from the buggy. However, the hazard remained in place. While focusing on placing additional scrap into the container, the employee moved closer than intended and contacted the protruding material.

The employee’s safety glasses were struck and pushed upward during the incident. Because the employee was wearing approved eye protection, their eyes were protected from what could have been a more serious injury.

Contributing Factors

  • Protruding scrap material created an exposed struck-by hazard.
  • The hazard was recognized but not eliminated or controlled.
  • Body positioning placed the employee within the hazard zone.
  • The scrap container was allowed to remain in an unsafe condition.

Lessons Learned

  • Hazard recognition alone is not enough. Identified hazards must be corrected whenever possible.
  • Keep scrap containers organized and do not allow conduit or other materials to extend beyond the container.
  • Reposition or cut long scrap pieces before disposal when needed.
  • Maintain awareness of body positioning when working around protruding materials.
  • Wear eye protection. In this incident, proper PPE helped prevent what could have been a significant eye injury.

 

 

Incident 2: Forearm Laceration During Drilling Operation

What Happened

An employee was drilling a hole in an 8″ × 8″ electrical box attached to an Orbit bracket when the drill bit bound. As the bit caught, the box rotated unexpectedly and drove the employee’s left forearm into a sharp metal edge, causing a laceration that required stitches.

Contributing Factors

  • Hazards were not fully identified during pre-task planning.
  • The workpiece was able to rotate when the drill bit bound.
  • The employee was exposed to sharp metal edges during drilling.
  • Controls were not sufficient to prevent unexpected movement of the material.

Lessons Learned

  • Secure materials before drilling whenever possible to prevent movement or rotation.
  • Anticipate drill bit binding, especially when drilling sheet metal or electrical enclosures.
  • Keep hands and forearms out of the potential path of movement if the workpiece shifts unexpectedly.
  • Evaluate sharp edge exposure during pre-task planning and implement appropriate controls.
  • Use proper drilling techniques, appropriate drill speeds, sharp bits, and steady pressure to reduce the likelihood of binding.

Safety Expectations

Every employee is expected to stop, evaluate the task, and correct identified hazards before work begins and whenever conditions change.

Before starting work, follow these expectations:

  • Eliminate hazards whenever possible rather than simply working around them.
  • Keep work areas clean and free of protruding materials.
  • Secure materials before drilling, cutting, or modifying equipment.
  • Maintain proper body positioning and stay out of the line of fire.
  • Wear required PPE.
  • If conditions change or a hazard cannot be adequately controlled, stop work and reassess the task with your supervisor before proceeding.

Key Takeaway

Both injuries occurred during routine tasks performed every day across our jobsites. These incidents reinforce that serious injuries can result when ordinary hazards become normalized or are not adequately controlled. Effective pre-task planning, hazard elimination, situational awareness, and staying out of the line of fire are critical to preventing injuries and ensuring every employee goes home safely at the end of the day.