Top 5 Mitti Safety Audit Focus Items from August 2026
Key Message
Over the past month, Mitti audits across the company have shown five recurring areas that require consistent attention: walking surfaces, clear egress, temporary lighting, cord management, and material storage. These items may seem basic, but they directly affect our ability to prevent slips, trips, falls, electrical hazards, blocked access, and struck-by exposures.
Why This Matters
Good housekeeping and safe access are not one-time tasks. Conditions change throughout the day as work progresses, materials are delivered, lighting is moved, cords are added, and multiple trades work in the same area. A work area that was compliant in the morning can become a hazard by lunch if we are not actively monitoring and correcting conditions.
Top 5 Items to Focus On
- Walking surfaces free of trip hazards: Keep walkways, platforms, stairs, and work areas clear of debris, scrap, cords, materials, and uneven conditions that can cause slips, trips, or falls.
- Means of egress kept clear: Maintain clear, usable paths into and out of the structure. Do not stage materials, carts, tools, gang boxes, or trash in access routes, stairways, doorways, or emergency exit paths.
- Temporary lights are properly secured: Temporary lighting must be installed and supported so it does not create a falling object, electrical, or trip hazard. Do not leave lights hanging by cords or where they can be damaged.
- Cords managed safely: Route cords out of walkways whenever possible, elevate or protect them when needed, avoid tangled runs, inspect for damage, and do not allow cords to create tripping hazards or pinch points.
- Materials stored properly: Store materials in designated areas, keep stacks stable, protect materials from rolling or shifting, keep them wind-safe where required, and avoid blocking panels, walkways, exits, or work access.
Supervisor and Crew Expectations
- Review these five items during daily huddles and Pre-Task Planning when they apply to the work area.
- Correct hazards immediately when they are identified. Do not assume someone else will take care of it.
- Reassess work areas throughout the shift, especially after deliveries, trade stacking, task changes, or weather impacts.
- Use Mitti audits as a tool to verify expectations, document conditions, and drive corrective action.
- Hold the standard: clear access, organized work areas, secured lighting, managed cords, and properly stored materials are expected on every project.
Crew Discussion
- Where are the most common trip hazards on our project right now?
- Are all access routes, stairways, and exit paths clear and usable?
- Are temporary lights secured properly and protected from damage?
- Are cords routed safely, protected, and inspected before use?
- Are materials stored in a way that prevents shifting, falling, or blocking access?
Key Takeaway
Most of these hazards are preventable when we slow down, look around, and take ownership of the area we are working in. Safe access, good housekeeping, secured temporary lighting, controlled cords, and organized material storage protect everyone on the jobsite. Safety starts with you: see the hazard, correct the condition, and protect the team.